Instructions, tips and tricks

Form

On most public playgrounds, the sandpit is square or rectangular and has a wide wooden seat. This variant is not only easy to create, it is also much cheaper to build yourself than a pre-purchased model. An inner and an outer wooden square, which is stabilized by the seat, form the basic structure.

Material list

• four boards for the outside. The length corresponds to the external dimension
• four boards for the seat
• four boards for the inside.
• Weed film
• Gravel to weigh down the foil
• Wood screws
• and of course a sufficient amount of play sand.

tool

• spade and shovel
• Cordless drill
• Staple guns and needles
• 4 small slats, string and hammer

The building instructions

preparation

First, use a batter board to mark the inner surface that you have to excavate for the self-made sandpit. Make sure that the edges of the created pit are straight and at exactly right angles to each other.

Draw the outer boards on a blueprint. The seat boards will later be screwed onto these with a little overhang. For example, if these are thirty centimeters wide and should later protrude five centimeters on both sides, the following calculation results:

Outer frame minus eight inches = inner frame.

Dig a pit

Sandpits should have a minimum depth of 15 centimeters. Since children like to dig, it can be a few centimeters more. Remember that a layer of gravel is also poured in and dig deep enough.

A layer of gravel, at least two centimeters thick, is then filled into the hole as drainage. This prevents the water from building up under the sandpit.

Assemble the sandpit

• Place the wooden boards for the inner surface in a square and screw them together from one side with at least four screws.
• Do the same with the boards for the outside.
• Place the outer one in the inner wooden rectangle and mount the seat over it.

Position the construction exactly on the edge of the excavated pit. Now fix a length of weed film on one of the inner sides and run it along the floor to the other side. The film serves as a weed barrier and ensures that no uninvited guests from the underground settle in the sandpit.

Fill the sandpit

Now we're almost done and it's time to fill the self-made sandpit. Use special play sand for this, which you can get in bags or loose in stores. It is characterized by the following properties:

• Dimensionally stable: Due to the grain size and the type of grain, sand cakes and castles hold together wonderfully.
• Clay-free: the washed one Quartz sand(€ 15.15 at Amazon *) does not leave ugly, yellow marks on clothing.
• Free of harmful substances: Play sand is TÜV tested and is guaranteed to be harmless to the little ones.

The needed amount

In contrast to purchased sandpits, where the filling quantity is often stated, you have to calculate the sand required for the sandpit built according to our instructions yourself. If the sandbox has an internal dimension of 120 centimeters by 120 centimeters and a depth of 30 centimeters, the following calculation results:

120 cm x 120 cm x 30 cm = 432,000 cm³ which corresponds to 0.432 m³.

Play sand is offered either in small bags, an inexpensive big pack with a cubic meter (1000 liters) or open.