Keeping rubber tree in hydroponics

How do I convert my rubber tree to hydroponics?

That Repot a hydroponic rubber tree that was previously kept in the ground is not that easy. On the one hand, the size of the tree plays a certain role, because a two-meter-tall rubber tree is not so easy to handle. On the other hand, careful work is necessary. It is imperative that you thoroughly remove all earth debris from the roots of your rubber tree so that the transfer can be successful.

It is best to rinse with water that is low in lime. Then put your rubber tree in a special inner pot for hydroponics and fill the container with it Expanded clay(€ 16.36 at Amazon *) on. By lightly tapping the pot on a firm surface, you distribute the clay evenly between the roots. to water Do not use your rubber tree very much, especially in the beginning.

How to hydroponically grow a cutting

A Cutting Growing hydroponically is much easier than moving an old rubber tree. Cut the cuttings as you normally would and hydroponically plant them for rooting.

How do I care for my hydroponic rubber tree?

Since the hydroponic rubber tree cannot draw nutrients from the soil, you have to take them with you fertilizer respectively. Add some commercially available liquid fertilizer or special hydroponic fertilizer to the irrigation water about every two to four weeks.

The water level should rather be in the minimum range so that the roots of your rubber tree get enough oxygen. If the water level indicator is permanently at maximum, then the roots could rot. You can, however, make an exception for your annual vacation.

Hydroponic tips for the rubber tree:

• Conversion is not that easy
• better to grow cuttings in hydroponics
• low water level in the planter
• Maximum water only in exceptional cases
• Choose a location that is as bright as possible