Sealing the yucca palm after pruning: wax & Co.

Sealing the interfaces on the Yucca palm primarily serves to protect against pathogens. What you have to pay attention to when choosing a material and some other tips for trimming are explained below.

Sense of sealing

The reasons for cutting off the also called Palm lily (Yucca filamentosa) known plant are of diverse nature. After the cut, it is advisable to seal the sore spots on the trunk of the yucca palm. The main reasons for this are as follows:

• Avoiding the ingress of pathogens
• Prevents the surface from tearing due to drought
• Reduction of the leakage of plant sap
• improved regeneration of the wound site

Materials and uses of tree and candle wax

A wide variety of wound closure agents are available commercially. In practice, the use of candle and tree wax is particularly known. In addition to a significantly cheaper procurement, the materials are already available in many households.

candle wax

A tea light is suitable for using candle wax. Light the candle and carefully drip the resulting liquid candle wax onto the wound site. Be careful not to apply too thick a layer. This presents the risk of flaking and thus the loss of the protective function.

Tree wax

In comparison, tree wax consists of natural resins. This can be made into a viscous paste. It is best to spread the wax thinly on the wound site with a spatula. Due to the similarity to the natural wound tissue of the plant, it is often better accepted by the plants than the candle wax.

Notice: The use of wax also has disadvantages when sealing the yucca palm. In this way, wax can accelerate the drying out of the wound site. This promotes the formation of cracks and the recurrence of sores.

Home remedies as alternatives

In addition to the two options mentioned above, many other materials have also proven themselves in practice for sealing wound areas on a yucca palm. These prevent the wound areas from drying out and cracking.

Clay

Clay is one of the oldest known binders and was previously used in particular in construction. The mixture of sand, silt and clay is an effective means of treating wound sites. Pour the mixture with water to make a spreadable paste. You can easily distribute these on the wound surface. To avoid hardening and drying out, you should then cover the clay layer with a film or adhesive tape.

When sealing the yucca palm with clay, you should pay attention to the following tips:

• Remove the foil and clay after ten days at the latest
• Allow the wound site to breathe for at least an hour
• Then renew the layer of clay and adhesive tape

Notice: The tape should she by no means antackern or annailnso that no further injuries occur.

cow dung

The use of cow dung is mainly known for fertilization purposes. Due to the high density and diversity of nutrients, manure is a natural complete fertilizer. Applying a mixture of cow dung, clay, lime, and water offers the following benefits:

• high breathability
• strong protection against dehydration and cold
• high light reflection
• additional support in wound healing through the nutrients it contains

It is not necessary to remove the applied manure layer. Since the materials used are completely biodegradable, the layer will dissolve by itself over time.

To make it, you use one part of cow dung, which you mix with two parts of clay and one part each of lime and water.

Charcoal

The charcoal is primarily known for its water-absorbing effect. It is therefore particularly suitable for weeping and infectious cuts. Crush the charcoal into a powder and apply it to the spots with your finger.

The breathable substance stimulates the formation of new cells. This also accelerates wound healing overall.

Notice: Despite the water-absorbing properties of the charcoal powder, it should not come into contact with large amounts of water. Especially bWhen pouring you should Splashing water vavoiden.

Emulsion paint

The use of emulsion paint for sealing the yucca palm has proven particularly useful for large-area cuts. Apply the finished emulsion to the affected areas using a brush. The emulsion paint offers the following advantages:

• high breathability
• prevents the wound areas from drying out
• effective protective barrier against bacteria and fungal spores

Notes on pruning

The palm lily is extraordinary cut compatible To be assigned to plants. It can therefore cope with radical cutbacks on the leaf crown and the trunk without any problems.

The ideal time for pruning the yucca palm is spring or the early summer. As a houseplant, however, it can be pruned all year round. Depending on the thickness of the branches and leaves, different tools can be used for cutting the yucca:

• Household scissors
• Secateurs
• knife
• Handsaw

Short cutting instructions

• dried up leaves cut off
• Remove protruding leaves
• Shorten the length of the protruding leaves to an appropriate length
• Cut the trunk into several parts depending on the size, minimum size of the individual sections: 20 centimeters
• Mark the top with a pencil or felt-tip pen
• Sealing the top of the trunk
• lower end of the trunk area back into the Earth set

frequently asked Questions