table of contents
- Different manufacturers - different dimensions
- Kronimus
- Wall washers (reinforced)
- Corner elements 90 ° outside corner, one-piece
- Corner elements 90 ° outside corner, two-part
- L-bricks (unreinforced)
- EHL
- Support bracket, length 100 cm
- Corner elements 90 ° outside corner
- Corner elements 90 ° inside corner
- frequently asked Questions
if Intercepted terrain should be, the hour of the corner stones strikes. Of the Garden design Up to the storey-high retaining wall, the most varied of dimensions offer the right L-stones for every application.
In a nutshell
- there are wall washers with and without additional metal inlays
- the dimension grid can vary from manufacturer to manufacturer
- A structural engineer should be consulted for large support heights
Different manufacturers - different dimensions
Although one would think that almost all of our products are subject to some standard, there is no binding system of measurements for angle stones. Many manufacturers use similar dimension grids, but in individual cases - especially with special components - these can deviate at any time.
Kronimus
One of the big manufacturers of L-stones is Kronimus. For high requirements, the manufacturer offers steel-reinforced wall panels, but unreinforced L-bricks made of concrete in various sizes for lower loads.
Wall washers (reinforced)
Corner elements 90 ° outside corner, one-piece
Corner elements 90 ° outside corner, two-part
Note: In addition, Kronimus offers various special molded parts, such as rounded "corners" or molded parts outside the 90 degree corners. The height dimensions are limited in their variety, but are generally based on the grid known from the standard stones.
L-bricks (unreinforced)
EHL
On the other hand, another well-known manufacturer, EHL, is relocating its angle stones, especially in the statically demanding area. The steel-reinforced L-stones are referred to here as "support brackets" and are available in different sizes.
Support bracket, length 100 cm
Note: All elements are also available in an overall length of 50cm. However, these corner stones are offered by EHL as a supplement to the 100 grid and are not marketed as independent wall panels.
Corner elements 90 ° outside corner
Corner elements 90 ° inside corner
Note: Further molded parts in other angles are available in the known grid, but with a limited height.
frequently asked Questions
Unreinforced concrete parts can only be loaded to a limited extent. They are therefore only suitable for low support heights, such as in garden design, for leveling driveways or for catching small excavations. The manufacturers therefore only offer them up to a height of around one and a half meters. Reinforced, i.e. reinforced with structural steel, angle components, on the other hand, can also absorb extreme loads and are therefore suitable for almost all areas of use around the house and garden.
Many manufacturers offer load tables from which you can choose the right products, taking into account the installation situation and the height of the ground. However, as soon as further structures are to be erected on the wall or heights of around 1.50 to 2.00 meters are exceeded, the dimensioning should definitely be carried out by a structural engineer.
Unreinforced corner stones can be cut with a suitable cut-off grinder. Reinforced molded parts, on the other hand, must not be changed, as otherwise the concrete cover of the iron is no longer given and the service life is significantly reduced.
