Bow hemp is quite easy to propagate. We will show you what you should know about propagating bow hemp by cuttings or division.
the bow hemp (Sansevieria) is not only a good air purifier and extremely easy to care for, it can also be easily propagated. With the right knowledge, you can set up a small mass production in no time.
Bow hemp is definitely one of those types of plants that can be propagated endlessly. Especially of the two popular types Sansevieria trifasciata and Sansevieria cylindrica you can never really have enough. Although the plants don't grow very fast, they tirelessly form new offshoots with young daughter rosettes all by themselves. You can also grow many small plants from the leaves without any problems.
Propagating bow hemp by cuttings
Bow hemp can be easily propagated by leaf cuttings. To do this, cut off a leaf just above the ground. It is best to choose a leaf that is still small so that the cutting is not too large. You can also cut long leaves into several parts, because the individual cuttings only need to be ten to fifteen centimeters long. Allow the interfaces to dry a little. Now you can put the leaves or parts of the leaves about a third into the prepared substrate.
With leaf parts, make absolutely sure that you put them in the right direction in the ground. They only grow roots if they are allowed to continue growing in their original direction of growth. The cuttings need a lot of time to develop and it can even take a few months before the little plants appear. Place the planter in a warm place and keep it moist but not wet.
Summary Propagating bow hemp through leaf cuttings:
- Cut off a small leaf just above the bottom
- Cut the leaves into 10-15 cm long pieces
- Stick one third of the leaf cuttings in the direction of growth into the substrate
- Place the planter in a warm place and keep it moist
The disadvantage of leaf cuttings is that the young plants can deviate from the breeding form of their mother plant. This is at Sansevieria trifasciata ˈLaurentiiˈ the case. It can happen that the plants develop back to their original form in this way and lose the yellow leaf edge.
Propagating bow hemp by division
Repotting is the optimal time to multiply the bow tie quickly and easily. With offshoots, cultivated forms are also preserved, which can be lost through cuttings. When you take your plant out of the pot, you will notice that it is usually no longer just a single plant. Over time, the arch hemp has formed offshoots whose daughter rosettes you can now separate. Untangle the intertwined roots and carefully separate the plants from each other. With a sharp and clean knife you can cut off the young seedlings close to the mother plant. Now you have one or more young plants that you can pot separately.
Like you boys Caring for bow tie plantlets properly, you will learn in this article.
